Introduction If your radiant tube heater has a flame-sensing issue, the flame sensor itself is not the only thing to check. Reverse polarity or an improper ground can also contribute to the problem. Checking the electrical supply helps determine whether either condition needs to be addressed before continuing with flame-sensor troubleshooting. For the Detroit […]
Read More
Introduction Detroit Radiant Products newest burner box design is referred to as the V3 Burner. This includes a service access door which can be opened while the unit is running for easier serviceability. This blog and video go over how to test a Transformer on these units. Testing the transformer on a Detroit Radiant Products […]
Read More
Introduction If a low-intensity radiant tube heater lights and then drops out, or locks out on flame sense, the flame rod is one of the first components worth investigating. A dirty flame rod, a loose connection, damaged wiring, or insufficient gas pressure can all prevent the control from confirming a proper flame. Before replacing parts, […]
Read More
Introduction – What is a ‘V3’ Burner? Detroit Radiant Products newest burner box design is referred to as the V3 Burner. This includes a service access door which can be opened while the unit is running for easier serviceability. This blog and video go over how to test a Gas Valve on these units. If […]
Read More
Introduction A forced air unit heater that shuts down unexpectedly may be reacting to a high limit or flame rollout switch issue. One of the clearest signs is the fan sequence: when there is a call for heat, the inducer fan and the room circulating fan start at the same time. Under normal operation, the […]
Read More
Introduction A radiant heater that will not ignite can sometimes come down to one small part: the hot surface igniter, commonly called a glow bar. Fortunately, diagnosing it is straightforward. All you need is a multimeter set to resistance, or ohms. An OL reading is often the first big clue. It usually means the igniter […]
Read More
Introduction If an electric heater is not producing heat, start with two straightforward checks: confirm that the heater has a call for heat, then verify that the heating element has continuity. These tests narrow the issue down quickly and help determine whether the problem is incoming power or a failed element. The Two Checks […]
Read More
Introduction Regular maintenance is one of the simplest ways to protect a DR Series radiant tube heater, maintain efficient operation, and avoid unnecessary repairs. Cleaning is straightforward, but the method matters. Too much compressed-air pressure or standing too close to the unit can damage critical gasket material around the ray head. The correct approach is […]
Read More
Introduction If you need to figure out whether a DR Series radiant tube heater has a bad gas valve, the process is straightforward when you use the right tools and check both power and gas flow. The key is not guessing. You want to confirm whether the valve is actually being energized and whether gas […]
Read More